Differences

This shows you the differences between two versions of the page.

--- en:supporting_other_locales [2020/07/28 02:33] – anupama
+++ en:supporting_other_locales [2020/07/28 02:34] – anupama
@@ Line 85: / Line 85: @@
 ===== ANOTHER RELATED SYMPTOM AND ITS FIX =====
+//We noticed the following symptom only once in the 3 test cases so far. It has not occurred in the remaining 2 test cases, so although we document its solution here, you may not need to carry out the
+instructions for this solution until you actual notice the problem (the symptom) described here.//
-. **SYMPTOM:** Unable to successfully and completely run certain perl scripts successfully such as ''perl -S pluginfo.pl -describeall'', despite setting up the Greenstone environment by running gs3-setup.\\ As a result, GLI may fail to launch properly.
+**SYMPTOM:** Unable to successfully and completely run certain perl scripts successfully such as ''perl -S pluginfo.pl -describeall'', despite setting up the Greenstone environment by running gs3-setup.\\ As a result, GLI may fail to launch properly.
 You can test if this is the case by opening a new DOS prompt, using it to navigate into your Greenstone 3 installation area and then running the following 2 commands in sequence there:\\<code>gs3-setup.bat