Differences

This shows you the differences between two versions of the page.

--- en:supporting_other_locales [2020/07/28 02:31] – anupama
+++ en:supporting_other_locales [2020/07/28 02:34] – anupama
@@ Line 84: / Line 84: @@
   * Try running GLI or the Greenstone Server and previewing your collection now. If there are still issues, see whether the DOS prompt contains error messages mentioning that mention issues running ''pluginfo.pl''. If so, see step 2 below.
+===== ANOTHER RELATED SYMPTOM AND ITS FIX =====
+//We noticed the following symptom only once in the 3 test cases so far. It has not occurred in the remaining 2 test cases, so although we document its solution here, you may not need to carry out the
+instructions for this solution until you actual notice the problem (the symptom) described here.//
-. **SYMPTOM:** Unable to successfully and completely run certain perl scripts successfully such as ''perl -S pluginfo.pl -describeall'', despite setting up the Greenstone environment by running gs3-setup.\\ As a result, GLI may fail to launch properly.
+**SYMPTOM:** Unable to successfully and completely run certain perl scripts successfully such as ''perl -S pluginfo.pl -describeall'', despite setting up the Greenstone environment by running gs3-setup.\\ As a result, GLI may fail to launch properly.
 You can test if this is the case by opening a new DOS prompt, using it to navigate into your Greenstone 3 installation area and then running the following 2 commands in sequence there:\\<code>gs3-setup.bat