Differences

This shows you the differences between two versions of the page.

--- en:developer:windows_source_install [2019/05/10 08:15] – [Current instructions] anupama
+++ en:developer:windows_source_install [2019/05/10 08:25] – [Current instructions] anupama
@@ Line 91: / Line 91: @@
-In GS2 SVN checkouts from **before changeset [[http://trac.greenstone.org/changeset/31428|31428]]**, compilation on 64 bit Windows could still fail with error messages as described [[http://wiki.greenstone.org/doku.php?id=en:developer:compiling_apache&#compiling_the_apache-httpd_included_with_gs2_on_64_bit_windows_7|here]], which indicates that the race condition has struck. In that case, try deleting the ''apache-httpd\windows\error'' folder if it has been generated, or all of the ''apache-httpd'' folder and run ''makegs2x64.bat'' again, choosing the same options as before. If the 'error' folder or ''apache-httpd'' folder did not exist and therefore can't be deleted, then just re-run makegs2x64.bat again. If that fails, run ''makegs2x64.bat'' and select the ''clean'' command (option 6) and then re-run ''makegs2x64.bat'' to re-compile from scratch. If doing so in a fresh command prompt, remember to run the 'devel64-in32mode.bat'' script in ''local'' before running ''makegs2x64.bat''.
+In GS2 SVN checkouts from **before changeset [[http://trac.greenstone.org/changeset/31428|31428]]**, compilation on 64 bit Windows could still fail with error messages as described [[http://wiki.greenstone.org/doku.php?id=en:developer:compiling_apache&#compiling_the_apache-httpd_included_with_gs2_on_64_bit_windows_7|here]], which indicates that the race condition has struck. In that case, try deleting the ''apache-httpd\windows\error'' folder if it has been generated, or all of the ''apache-httpd'' folder and run ''makegs2x64.bat'' again, choosing the same options as before. If the 'error' folder or ''apache-httpd'' folder did not exist and therefore can't be deleted, then just re-run makegs2x64.bat again. If that fails, run ''makegs2x64.bat'' and select the ''clean'' command (option 6) and then re-run ''makegs2x64.bat'' to re-compile from scratch. If doing so in a fresh command prompt, remember to run the <del>''devel64-in32mode.bat''</del> ''setup.bat'' script in ''local'' before running ''makegs2x64.bat''.
 </TAB>